TM 10-4610-310-14
0102 00
HOUR METER - continued
3. Disconnect two wires on back of hour meter
4. Remove three screws and nuts from bezel of hour meter.
5. Remove hour meter from cutout in panel.
Installation
1. Install hour meter through cutout in panel.
2. Install three screws and nuts to secure hour meter to panel.
3. Connect two wires to connectors on rear of hour meter. Observe number tags and prior notes for proper
connection.
4. Install inner panel over hour meter wiring. Install eighteen screws. Tighten securely.
PILOT LIGHT (INDICATOR)
Removal
1. Remove eighteen screws. Remove inner panel for access to pilot light wiring and mounting.
2. Make note of the wire numbers on rear of pilot light.
3. Remove wires from connector.
4. Loosen lock nut on front of pilot light.
5. Remove lock nut.
6. Remove pilot light through rear of cutout.
Installation
1. Install pilot light through cutout in panel.
2. Position and locknut on pilot light.
3. Tighten locknut securely.
4. Connect wires to connections on pilot light. Observe number tags and prior notes for proper connection.
5. Install inner panel over pilot light wiring. Install eighteen screws. Tighten securely.
PILOT LIGHT BULB REPLACEMENT
1. With power applied, test operation of bulb by pressing the bulb in. It will come on if serviceable.
2. To remove a burned out bulb, unscrew lens cap.
3. Use the 3/8" rubber hose provided (light bulb removal tool) to push and twist out bulb.
4. Push in and twist new bulb by using the same hose. Install lens cap.
PUSH-PULL SWITCH (EMERGENCY STOP) (SW9)
Removal
1. Remove eighteen screws. Remove inner panel for access to switch wiring and mounting.
2. Make note of the two wire numbres on rear of switch.
3. Remove two wires from connector.
4. Remove EMERGENCY STOP knob.
5. Loosen lock nut on front of push-pull switch.
6. Remove and push-pull switch through cutout in panel.
0102 00-3
