TM 10-4610-310-14
0102 00
CIRCUIT BREAKER (CB1) - continued
Installation
1. Place circuit breaker on mounting plate. See Figure 3.
2. Install the two slotted screws through circuit breaker.
3. Connect the wires to circuit breaker. Observe number tags and prior notes for proper connection.
4. Insert depth shaft into circuit breaker and replace two mounting screws.
5. Close panel to make sure depth shaft interfaces with circuit breaker.
MOTOR STARTER MODULE (M1 M4)
Removal
1. Make note of number and location of all wires on motor starter module. See Figure 3.
2. Remove all wires from motor starter module.
3. Insert screwdriver into bottom clip release. Press down.
4. Pull motor starter module from mounting bracket.
Installation
1. Place motor starter module on mounting bracket.
2. Rotate motor starter module into locking position.
3. Connect all wires to motor starter module. Observe number tags and prior notes for proper connection.
SURGE SUPPRESSOR (SP2 SP21)
Removal
1. Grasp surge suppressor. See Figure 3 and Figure 4.
2. Pull up from mounting socket.
Installation
1. Insert surge suppressor into mounting socket.
2. Push down to lock into position.
0102 00-5
