TM 10-4610-310-14
UNIT MAINTENANCE
LIGHTWEIGHT WATER PURIFIER
CONTROL MODULE COMPONENTS
REMOVAL/INSTALLATION
INITIAL SETUP
Tools
Equipment Condition Required
Tool Kit, General Mechanics,
All equipment de-energized and shut off.
Automotive
Material/Parts
Material/Parts - continued
Relay, control, SPDT, (PN 700-HK36A1)
Rags, cotton, (item 21, WP 0136 00)
Module, start, 18-amp, (PN LD1LB030FC)
Switch, 2-position, (PN 10250T20LB)
Module, start, 2.5-4 amp, (PN LB1LB03P08)
Switch, 3-position, (PN 10250T21LB)
Module, start, auxiliary, (PN LA1LB019)
Switch, 4-position, (PN10250T46LB)
Suppressor, surge, (PN SPP-120AD)
Hour meter, 0-99999.9 hours, (PN T50B2-
12)
Suppressor, surge, 230 VAC, (PN UAK 2/2-
230AC-ST)
Breaker, circuit, 20 amp, (PN GHC2020)
Suppressor, surge, 120 V, (PN UAK 2/2-120AC-
Light, pilot, (PN 10250T221N)
ST)
Bulb, pilot light, (PN 755)
Controller, motor, (TL480N15)
Block, circuit breaker, (PN1492-GS1G100)
Board, terminal, 600V, (PN 1492-W6)
Button, push-pull, emergency stop,
Handle, mechanism, (PN HRGCV14L)
(PN 10250T5B63-1X)
Module, starter, (PN LA4DE2U)
Button, push, (PN 10250T101)
Block, terminal, 600V, (PN1492-WM3-W)
Block, terminal, 600 V, (PN1492-WM3-BL)
Safety wire, (MS20995-32)
Block, circuit breaker, 10 amp, (PN 1492-
Remover/installer, contact pin
GS2G100)
Tie Wraps, (item 30, WP 0136 00)
GENERAL
This work package contains information and instructions for removal and installation of the internal components
in the control module used in the Lightweight Water Purifier (LWP). Make sure to tag any wiring removed from
the components to assist in the installation.
OPEN CONTROL MODULE
1. Place circuit breaker CB1 in the OFF position. Turn handle mechanism.
2. Unscrew eight screws on the cover clamps. Slide clamps away from panel. See Figure 1.
3. Rotate CB1 handle back and forth to release handle from internal circuit breaker. Hold interlock on upper
right of handle down and push up on handle.
4. Open control module enclosure door to access components.
SWITCH, 2-POSITION/3-POSITION/4-POSITION (SW1 SW8, SW 10 SW11)
Removal
1. Remove eighteen screws. Remove inner panel for access to switch wiring and mounting.
2. Make note of wire numbers on rear of switch for ease of reinstallation.
3. Disconnect wires on the back of the switch.
0102 00-1
