TM 10-4610-310-14
0106 00
REMOVAL- continued
2. Remove Victaulic clamp from victaulic adapter on end of the pressure vessel assembly. Slide gasket onto
opposite victaulic adapter.
3. Support pressure vessel assembly at both ends.
4. Remove two nuts and washers from U-bolt and remove the U- bolt. See Figure 2.
5. Remove pressure vessel assembly from RO element module.
4
5
6
7
VICTAULIC
U-BOLT
CLAMP
WASHER
1
3
2
NUT
Figure 2. Pressure Vessel Mounting Hardware.
RO REJECT PIPING
1. Remove the victaulic clamp from the tail end of vessel number 7. See Figure 3.
2. Loosen tubing nut (9) from elbow (10).
3. Remove the nuts (5), washers (4) and U-bolts (6). Remove the piping from the module.
4. Remove adapter (3), male camlock (2) and dust cap (1) if necessary.
5. Disassemble RO reject valve (8) if necessary. See WP 0129 00.
Figure 3. Reject Piping Assembly.
